Mini Guide to Servicing and Maintaining Yamaha Bikes

A vehicle of any kind, be it a car or a bike, is an investment with a long-term horizon. However, just like any other piece of machinery, as time passes, automobiles lose some of the optimal fuel economies that they had when they were first manufactured. Additionally, the parts start to slow down, which has an effect not only on the speed of the automobile but also on the driver. This is true in particular for scooters and motorcycles since they’re smaller vehicles that are subjected to a greater amount of wear and tear. But then you can prevent all of this if you do routine maintenance and servicing on your Yamaha bikes and do it following the recommendations given to you by your service provider. Additionally, there are some activities that you can carry out all by yourself, in the comfort of your own house. To assist you, below are a few maintenance and repair pointers for your Yamaha bikes.

First service: between 500 and 700 kilometers

When a motorcycle has been used for between 500 and 700 kilometers (one month), the very first service is performed on it. Throughout this maintenance, the engine oil will be replaced, and the water system will be serviced. Changing the oil is recommended by manufacturers even though the amount of oil used remains extremely low. This is because there is a greater likelihood of oil contamination because of the presence of small amounts of metal within the tank during the process of setting up a new engine.

Tire pressure

You must check the pressure on your tires to guarantee that you are traveling safely. If the pressure is low, you run the risk of a flat tire or a blowout at great velocity. If the limit is exceeded, this may impair how well the Yamaha bikes can be handled. Typically, the measurements of the appropriate air pressure can be found in the manual that was provided by the tire manufacturer. Make sure to check the PSI level of your tires with a tire pressure tester, and then inflate them as necessary.

Tension in the chain

Improper chain tension could result in premature wear just on sprockets and gearbox, as well as jerky gear shifts as well as a transmission that is difficult to control. Additionally, it may restrict the travel of such rear suspension and also shorten the life of such a drive chain.

You can find instructions regarding how to alter the chain tension on the bike in the manual that came with the workshop. Ensure to establish the tension with the load just on the bike (ideally with a person on it), as even the chain would tighten up if a rider is on board, and you should set the tension with just some load just on the bike.

While retightening, it is crucial to use the right amount of force, which is specified in the owner’s handbook as the appropriate torque settings for every bolt. For this to be done correctly, you will need a torque wrench of sufficient quality.

Make sure the oil level is correct

When it comes to maintaining your bike, keeping in mind that the engine should be inspected among the essential maintenance advice, it is the engine oil that makes it possible for the Yamaha bikes to run without any hiccups. You have the responsibility of ensuring that the correct engine levels are being maintained and checking for any leaks that may be present. The presence of carbon deposits within the oil can cause the oil to become more viscous, which in turn can affect the engine of a motorcycle. Riding the motorcycle with contaminated engine oil not only increases fuel economy but also significantly decreases the engine’s lifespan.